Interlogix TruVision 960H Premium Resolution Series PTZ Cameras Installation Manual - Manual (Page 11)

EN 11 TruVision Analog PTZ Camera
9. Re-attach the bubble by screwing it into the housing.
Warning: After installation, the PTZ module will perform a PTZ
self-test and initializes with the power on. DO NOT touch and
move the camera while it is self-testing and initializing.
DIP switch settings
Two DIP switches, SW1 and SW2, are used to set the PTZ dome
address, baud rate, protocol, etc. The values are ON=1 and OFF=0.
See Figure 2 on page 12.
Each DIP switch number represents a DIP switch value, ranging from 1
to 8 from the lowest to highest.