Interlogix TruVision 960H Premium Resolution Series PTZ Cameras Installation Manual - Manual (Page 6)

EN 6 TruVision Analog PTZ Camera
Installing a camera
Pendant-mount cameras
1. Prepare the mounting surface and install the camera bracket.
2. Unscrew the bubble from the camera and remove the protective
tape from the PTZ module.
3. Press the two tabs on either side of the PTZ module and remove it
from the camera housing.
4. Configure the communication parameters for the PTZ camera.
Please see Section DIP Switch Settings for detailed information of
communication parameters settings.
5. Route the cables from the pendant-mount bracket, and connect it
to the PCB of the module through the cable entry hole on top of the
housing.
Note: If alarm and audio input/output relays are to be used, also
connect them to the PCB of the module.
6. Attach the camera housing to the bracket using the screws
enclosed with the bracket.
7. Insert the PTZ module into the housing:
Position the tabs on the PTZ module by aligning the arrow label on
the module with those on the housing (see below). The module
should snap firmly into position. If using an SD card, insert it into
the module before inserting the module into the housing.
8. Re-attach the bubble by screwing it to the housing.