Interlogix TruVision 960H Premium Resolution Series PTZ Cameras Installation Manual - Manual (Page 7)

EN 7 TruVision Analog PTZ Camera
Flush-mount cameras
1. Using the drill template, drill a hole on the ceiling.
2. Unscrew the bubble from the camera and remove the protective
tape from the PTZ module.
3. Press the two tabs on either side of the PTZ module and remove
the module from the camera housing.
4. Configure the communication parameters for the PTZ camera. See
the section “DIP switch settings” on page 11 for detailed information
on the communication parameters settings.
5. Adjust the height of the two housing tabs by turning the screw on
which they are attached. The distance (h) of the tabs from the
housing ring must be greater than the thickness of the ceiling.
Housing tab
Screw
6. Make sure the housing tab is closed and then PUSH the housing
into the pass-through hole. Hold the housing and fix it by screwing
the housing tabs down to the mounting surface.
7. Insert the PTZ module into the housing: