Interlogix TruVision IP Open Standards Dome Cameras Installation Manual - Manual (Page 13)

Installation Manual 13 EN
3. Pull the camera’s cabling through the ceiling hole and connect to the devices
and power.
If needed, seal all mounting holes so that no moisture can leak into the
mounting surface.
4. Adjust the camera’s angle of view while watching the image on a monitor.
Loosen the lens positioning
screws (1).
Using the supplied hex
wrench, adjust the camera
pan and tilt horizontally and
vertically.
Tighten the lens positioning screws.
Note: The lens focus has been adjusted in the factory so should not require
further adjusting.
5. Reattach the camera housing and tighten the fixed screws and. Ensure that
the camera is firmly attached to the ceiling.