Interlogix TruVision IP Open Standards Dome Cameras Installation Manual - Manual (Page 7)

Installation Manual 7 EN
3. Mount the camera to the ceiling using the appropriate fasteners. See
“Mounting the dome cameras on a ceiling” on page 10.
4. Set up the camera’s network and streaming parameters so that the camera
can be controlled over the network. For further information, please refer to
the “TruVision IP Camera Configuration Manual”.
5. Program the camera to suit its location. For further information, please refer
to the “TruVision IP Camera Configuration Manual”.
To quickly put the wedge dome camera into operation:
1. Prepare the mounting surface.
2. Connect the power and network cables to the camera. See “Wedge dome
camera connections” on page 9.
3. Mount the camera to the ceiling using the appropriate fasteners. See
“Mounting the wedge dome cameras on a ceiling” on page 12.
4. Set up the camera’s network and streaming parameters so that the camera
can be controlled over the network. For further information, please refer to
the “TruVision IP Camera Configuration Manual”.
5. Program the camera to suit its location. For further information, please refer
to the “TruVision IP Camera Configuration Manual”.
Connecting the devices
A qualified service person, complying with all applicable codes, should perform
all required hardware installation.
Dome and IR dome camera connections
Note: Do not attempt to extend the power/data cable connection using RJ45
couplers and Cat5 cable. Only use the data cable connection provided.
Note: Use 12 VDC or PoE.