Camera description, Setting up the camera – Interlogix TruVision IP Open Standards Dome Cameras Installation Manual User Manual
Page 6
Advertising
EN 6
Installation Manual
Cable type
Requirements
Power 12
VDC
cable
Camera description
Figure 1: IP dome and IR dome cameras
Figure 2: IP wedge dome camera
Setting up the camera
Note:
If the light source where the camera is installed experiences rapid, wide-
variations in lighting, the camera may not operate as intended.
To quickly put the dome camera into operation:
1. Prepare the mounting surface.
2. Connect the power cable (optional), alarm I/O cables, RS-485 cable, audio
cables and network cable to the camera. See “Dome and IR dome camera
connections” on page 7.
Advertising