Interlogix TruVision IP Open Standards Dome Cameras User Manual - Manual (Page 27)

2BChapter 3: Network and streaming configuring
Configuration folders Description
Serial settings Defines the RS-485 and RS-232 communication settings. See
“Serial port settings” on page 25.
Alarm parameters Defines how the camera handles alarms such as input type,
notification of alarms, and response schedules and duration.
See “Alarm parameters” on page 30.
Deployment time Defines the schedules during which events are registered.
See “Events scheduling” on page 31.
User management Defines who can use the camera, their passwords and access
privileges. See “User management” on page 41.
HDD management Defines how to format the SDHC card used in the camera.
See “Formatting the SDHC card” on page 44”.
Remote upgrade Defines how to upgrade the camera’s firmware. See
“Upgrading the firmware” on page 44.
Default Restores default settings. See “Restoring default settings” on
page 44.
Reboot device Reboots the camera. See “Rebooting the camera” on page
45.
Information about the camera
Use the “Basic configuration” menu to define the camera name and RS-485 bus
ID. The default device name is “IP Camera” and device ID is 88. The camera can
have up to 12 alphanumeric characters in its name.
Several parameters are also prepopulated and cannot be changed manually
such as the camera, encoder, panel and hardware versions.
Network parameters
Accessing the camera through a network requires that you define certain network
settings. Use the “Network Parameters” folder to define the network settings. See
Figure 11 on page 24 for further information.
Note:
When a network parameter is modified, the camera will prompt you to save
and reboot.
TruVision IP Dome Open-Standards User Manual 23