Interlogix TruVision IP Open Standards Dome Cameras User Manual - Manual (Page 40)

3BChapter 4: Configuring the camera
You can define the area on screen where the motion is detected, the level of
sensitivity to motion, the schedule when the camera is sensitive to detecting
motion as well as which methods are used to alert you to a motion detection
alarm.
Use the “Motion detection” screen in the “Channel parameters” folder to change
the motion detection settings.
The recording schedule of the motion detection must fall within the time period of
the event schedule in order to operate correctly. See “Events scheduling” on
page 30 for more information.
Figure 17: Motion detection menu
Defining a motion detection alarm requires the following tasks:
1. Events schedule: Define the schedule during which the system inputs and
outputs are operational to detect alarms. See “Events scheduling” on page
30.
2. Recording schedule: Define the schedule during which motion detection can
be recorded. See “Defining a recording schedule” (see page 34).
3. Settings areas: Define the on-screen area that can trigger a motion detection
alarm and the detection sensitivity level. See below.
4. Linkage: Specify the method of response to the alarm. See below.
To define the motion detection areas and response method:
Note
: The deployment and motion detection recording schedules must also be
defined for motion to be detected and recorded. See “Events scheduling” on
page 30 and “Defining a recording schedule” on page 34.
36 TruVision IP Dome Open-Standards User Manual