Interlogix TruVision IP Open Standards Dome Cameras User Manual - Manual (Page 31)

Chapter 4
Camera configuration
This chapter explains how to configure the cameras through a Web browser.
You must have administrator rights on your PC in order to configure the cameras
over the internet.
Camera parameters
This section describes how to configure the camera settings from the Channel
Parameter screen. There are eight subfolders, which are described below:
• Display settings: Defines how the date and time are displayed on screen. By
default the name appears in the lower right corner of the screen and the
date/time on the top. See “Defining how information is displayed on screen”
on page 28 for information on defining the camera name.
• Video settings: Defines how the camera records an event. The stream
mode, stream type, resolution, image quality, bit rate, frame rate, and video
compression can all be modified. See “Defining the system time” on page 29
for more information.
• Schedule record: Defines the recording schedule of the camera. See
“Defining a recording schedule” on page 34.
• Motion detection: Defines the on-screen area to trigger a response and the
method of response. See “Motion detection alarm” on page 35.
• Text overlay: Defines up to four lines of extra text on-screen. They can be
positioned anywhere. See “Adding extra on-screen text” on page 38.
• Camera image settings: Defines image quality parameters as well as
camera behavior such as shutter speed, iris mode, day/night mode, IR mode,
image flip, power mode and white balance.
• Time & date: Defines the synchronization of the time and date with the NTP
server.
TruVision IP Dome Open-Standards User Manual 27