Interlogix IS-ZW-RC-1 - Manual (Page 6)

The screen displays SUCCESS.
All-on and all-off control
The factory default setting for Z-Wave lighting control devices is to
be included in all-on and all-off control.
To turn all devices on or off:
1. Press ALL once.
The screen displays ALL.
2. Press either ON or OFF (you can press any ON or OFF button).
The screen displays ALL ON or ALL OFF, depending on the
key you pressed.
To add devices to All control mode:
1. Press and hold SETUP until the screen displays LIGHT
SETUP
.
2. Scroll until the screen displays ALL SETUP, and then press
OK
The screen displays EX ON/OFF.
3. Scroll until the screen displays INC ON/OFF, and then press
OK.
The screen displays SETUP WAITING.
4. Press the button on the device that you wish to add to All
control mode.
The screen displays SUCCESS.
To delete devices from All control mode:
1. Press and hold SETUP until the screen displays LIGHT
SETUP
.
2. Scroll until the screen displays ALL SETUP, and then press
OK.
The screen displays EX ON/OFF.
3. Press OK.
The screen displays SETUP WAITING.
4. Press the button on the device that you wish to remove from
All control mode.
The screen displays SUCCESS.
Time and date setup
You will need to reprogram the date and time when the batteries
are replaced.
To set the time:
1. Press and hold SETUP until the screen displays LIGHT
SETUP
.
2. Scroll until the screen displays DATE/TIME, and then press
OK.
The screen displays TIME.
3. Press OK.
The screen displays TIME 12 hr.
Press ON or OFF with the 1 key to adjust the hour.
Press ON or OFF with the 2 key to adjust the minutes.
Press ON or OFF with the 3 key to toggle between AM and PM.
4. Once you have set up the correct time, press OK.
The screen displays SUCCESS.
To set the date:
1. Press and hold SETUP until the screen displays LIGHT
SETUP
.
2. Scroll until the screen displays DATE/TIME, and then press
OK.
The screen displays TIME.
3. Scroll until the screen displays DATE, and then press OK.
The screen displays the default date.
Press ON or OFF with the 1 key to adjust the month.
Press ON or OFF with the 2 key to adjust the day.
Press ON or OFF with the 3 key to toggle between years.
4. Once you have set up the correct date, press OK.
The screen displays SUCCESS.
To set the current day:
1. Press and hold SETUP until the screen displays LIGHT
SETUP
.
2. Scroll until the screen displays DATE/TIME, and then press
OK.
The screen displays TIME.
3. Press the right arrow twice.
The screen displays DAY.
4. Scroll until the current day is displayed, and then press OK..
Note: The DTS and Time Zone settings are reserved for future use.
Events
An event is something you want to happen at a specific time and
day. This could be everyday, a specific day of the week, Monday
through Friday, Saturday and Sunday only, or a one-time
occurrence. Events can be set up to control an individual device, a
group, or a scene.
The remote allows you to program up to 15 automated events.
You must set the time and date before programming an event.
To add an event:
1. Press and hold SETUP until the screen displays LIGHT
SETUP
.
2. Scroll until the screen displays EVENTS, and then press OK.
6 of 8 P/N 1069507 • REV A • ISS 18NOV09