Interlogix TruPortal User Manual
Page 24
Preparing for Configuration
12
TruPortal Software User Guide
6.
Log in as a user with Execute permissions for the Firmware Updates feature, and then click
[Next].
The Source File page displays details about the firmware on the System Controller.
7.
Click [...] to browse to the folder where the NGP.bin file was downloaded.
8.
In the Open dialog box that appears, click the NGP.bin file to select it, and then click [Open].
The Source File page displays details about the NGP.bin file.
9.
Click [Next].
10.
On the Backup page, type the path where data will be backed up, or browse to its location.
Note:
Although the Create Backup File check box can be cleared to skip backing up data, it
is recommended that users leave this check box selected to back up data before an
upgrade. This option is intended for factory use only.
IMPORTANT: If no backup file is created while using the Upgrade Wizard, photos will not be
preserved and will need to be restored from an earlier backup.
11.
Click [Backup].
12.
When a “Backup Successful” message appears, click [Next].
13.
On the next page, click [Firmware Upgrade].
A summary of the Upgrade Wizard’s progress appears. This process may take five to ten minutes.
Red squares will appear next to any errors that occurred.
14.
When the upgrade is complete, click [Next].
15.
If data was backed up in
, the Restore page displays the location to which files were
backed up.
a.
Click [Restore] to load the backed up data back onto the System Controller.
b.
When the “Restore Successful” message appears, click [Next] to verify that the upgrade
occurred on the Upgrade Results page.
16.
When the Upgrade Results page appears, click [Finish] to exit the wizard.
17.
If a goEntry System was upgraded to TruPortal, review the card format descriptions on the
System Administration > Card Formats page and update them, if necessary. (Card format
descriptions are upgraded in English only.)
18.
If IPSDCs are installed, configure each IPSDC to recognize the IP address of the System
Controller before configuring the IPSDC in the User Interface. See