Country Home Products 18 HP - Manual (Page 21)

CALL TOLL FREE 1-800-DR-OWNER 17
Attaching the Discharge Chute (19 HP Top Discharge model)
Tool Needed:
•
(2) 1/2" Wrench or Socket
1. Loosen the two (2) 5/16"-18 x 4" Bolts on the Chipper Rear Side Panel (Figure 3) just enough so
that the top L-shaped notches in the Mounting Plates on the Discharge Chute will slide onto the
Bolt. You may have to slightly tap the Nut side of the Bolt to center it before the Discharge Chute
can easily slide into place.
2. After the top L-shaped notches are in place on the Bolt, pivot the Discharge Chute down so that the
lower slots slide over the lower Bolt as shown in Figure 3.
3. Once the Discharge Chute is in place on the Bolts, securely tighten the two (2) Lock Nuts.
NOTE: Check that the Safety Interlock Switch button is depressed by the Mounting Bracket on the
Discharge Chute. If the button is not properly depressed, the engine will not start.
Figure 3
Chipper Rear Side Panel
Chipper Hopper
Discharge Chute
Bottom L-Shaped
Notch (2)
Top L-Shaped
Notch (2)
5/16" x 4" Bolts (2)
Scroll
Safety Interlock Switch
located on opposite side.
Mounting Bracket
Safety
Interlock
Switch