Cabletron Systems SPECTRUM SEHI100TX-22 - Manual (Page 19)

Using the Hub View 2-5
Using the SEHI100TX Hub View
Note that the Device menu does not provide access to every application which is
available to the SEHI100TX; some information is only available from the Module
or Port menus, and several applications can only be accessed either from the icon
menu (if you are running under a network management platform) or from the
command line (if you are running in stand-alone mode). See Chapter 1,
Introduction to SPMA for the SEHI100TX-22
, for a complete list of applications
available to the SEHI100TX and how to access each one.
If you need to call CabletronÕs Global Support about a problem with the Hub
View application, youÕll need the information provided in the Info window
(
Figure 2-3 ):
Figure 2-3. The Hub Information Window
Clicking mouse button 1 on the Quit button closes all Hub View application
windows; any open applications which can also be accessed from the command
line or from the icon menu will remain open.
Using the Mouse in the Hub View Ports Display
Each device in your SEHI100TX-managed HUBStack will have its own ports
display in the Hub View; you can access the available ports displays by using the
scroll bar located on the right side of the Hub View Ports Display window, as
illustrated in
Figure 2-4 . The illustration below also indicates how to use the
mouse to access the Module and Port menus and functions.
SPMA for the SEHI100TX
application version
SEHI100TX firmware revision,
firmware boot prom version, and
hardware version