Cabletron Systems SPECTRUM SEHI100TX-22 - Manual (Page 41)

Enabling and Disabling Link/Seg Traps 3-5
Link/Seg Traps
Figure 3-3. The Module Traps Window
3. In the Module Traps window, click mouse button 1 to select the module for
which you wish to configure link and segmentation traps.
• If the Set Trap Status For field displays Selected Modules (the default
setting), you can click to select any modules; to de-select any highlighted
module, click on it again.
• If the selection All Modules is displayed in the Set Trap Status For field,
all available modules will be automatically selected; if you de-select any
module, the Set Trap Status For field will automatically revert to the
Selected Modules setting.
To change the setting in the Set Trap Status For field, click on the currently
displayed setting, and drag down to select a new setting.
4. Click on the appropriate selection in the Link Traps field to Enable or Disable
link traps for the selected modules, as desired.
5. Click on the appropriate selection in the Segmenting Traps field to Enable or
Disable segmenting traps, as desired.
6. Click on to save your changes; click on to exit the
window.