CNet Technology CWR-800 - Manual (Page 10)

3. Power on the cable or DSL modem.
4. Connect the power adapter to the Power port, and then plug the power adapter into a power
outlet.
•
The Power LED on the front panel will light up green as soon as the power adapter is connected
properly.
4. Power on one of the PCs on your wireless network(s).
5. For initial access to the Router through a wireless connection, make sure the PC’s wireless
adapter has its SSID set to CNET_Wireless (the Router’s default setting), and its WEP
encryption is disabled. After you have accessed the Router, you can change the Router and
this PC’s adapter settings to match the your usual network settings.
The Router’s hardware installation is now complete. Go to “Chapter 4: Configure the PCs.”