9 adjusting the printing, Adjusting the printhead position, 9 adjusting the printing -42 – Canon W7250 User Manual
Page 54: Adjusting the printhead position -42, P.1-42
Setting Up the Printer
42
1-42
Note
9 Adjusting the Printing
After confirming that the nozzles are operating normally, print the printhead
alignment pattern and set each adjustment value. Before printing, make sure
A3 size or larger media is set.
Adjusting the Printhead Position
Execute “Print Pattern A” then do the settings for “A” ~ “K” to adjust the
printhead.
z You should use the most frequently used media to make the printhead adjustment.
z If you are using cut sheets, make sure at least three sheets of unused A3 paper (not
the blank sides of used paper) or larger are set. The printhead adjustment procedure
with cut sheets is slightly different, so just follow the instructions on the display.
1
If the printer is off, press the Power button to switch the printer on.
After a few seconds “Online” is displayed in the operation panel and the
Online lamp lights.
2
Press the Online button twice to display “MAIN MENU”.
Enter
Cancel
Cut Sheet
Roll Media
Paper Source
Data
Message
Power
Online
Enter
Cancel
Cut Sheet
Roll Media
Paper Source
Data
Message
Power
Online