Crestron electronic DIN Rail Control Processor DIN-AP2 - Manual (Page 27)

Crestron DIN-AP2 DIN Rail Control Processor
marked Ethernet however, communications must be established in
order to see this information in the “System Info” window.
• Display the DIN-AP2’s “System Info” window (click the
icon); communications are confirmed when the device information
is displayed.
TCP/IP
Ethernet Communication
ETHERNET
PC RUNNING
CRESTRON
TOOLBOX
DIN-AP2
• Establish USB communication between DIN-AP2 and PC.
• Enter the IP address, IP mask, and default router of the DIN-AP2
via the Crestron Toolbox (Functions | Ethernet Addressing);
otherwise enable DHCP.
• Confirm Ethernet connections between DIN-AP2 and PC. If
connecting through a hub or router, use CAT5 straight through
cables with 8-pin RJ-45 connectors. Alternatively, use a CAT5
crossover cable to connect the two LAN ports directly without
using a hub or router.
• Use the Address Book in Crestron Toolbox to create an entry for
the DIN-AP2 with the DIN-AP2’s TCP/IP communication
parameters.
• Display the “System Info” window (click the
icon) and select
the DIN-AP2 entry.
• Use Crestron Toolbox to create the DIN-AP2 IP table.
⇒ Select Functions | IP Table Setup.
⇒ Either add, modify, or delete entries in the IP table. The
DIN-AP2 can have only one IP table entry.
⇒ A defined IP table can be saved to a file or sent to the
device.
• When using the DIN-AP2 as a “slave”, edit the “master” control
system’s IP table to include an entry for the DIN-AP2. The entry
should list the DIN-AP2’s IP ID (specified on the DIN-AP2’s IP
table) and the internal gateway IP address 127.0.0.1.
Operations & Installation Guide – DOC. 6662A DIN Rail Control Processor: DIN-AP2
• 23