Vermont Casting 43LDVT - Manual (Page 23)

23
LDVT Series Direct Vent GaS Fireplace
10007852
36LDVT
1. Place rear log (B158) on rear brack-
et (ensure log is seated properly to
the bracket and located to the two
pins), so it will not move from side to
side and is firmly positioned on the
bracket.
2. Place front left log (B160). Use the
log’s bottom hole to locate it onto
the front support and just rest on top
of the rear log.
3. Place front right log (B159). Use the
log’s bottom hole to locate it onto
the front support and the top hole to
the knob onto the rear log.
4. Place front center log (B161) on top
of the two small shelves at the front
log support and between the left
and right logs.
5. Place ember material on top of
burner. Scatter the ember material
over the tiles on the front area of
the burner housing. (Fig. 45) Do not
pack the ember material. Separate it when unpacked
and keep it in a fluffy and loose condition for a more
realistic ember effect.
6. Scatter the lava rock material around the firebox
base. �����
����������
����
Rear
(B158)
Front Left
(B160) Front Center
(B161)
Front Right
(B159)
LG481
Fig. 38 Correct log placement for 36LDVT.
Do not place any of the lava rock material
on the burner housing assembly.
39LDVT
1. Place rear lob (BC14) on rear bracket
(ensure log is centered and seated
properly to the log support).
2. Place front left log (BC15). Use log’s
bottom hole to locate it onto the front
support and just rest on top of the
rear log.
3. Place front right log (BC16). Use log’s
bottom hole to locate it onto the front
support and the top hole to the knob
on the rear log.
4. Place front center log (B138) on top
of the two small shelves at the front
log support, and between the left and
right logs.
5. Place ember material on top of
burner. Scatter the ember material
over the tiles on the front area of the
burner housing. (Fig. 46) Separate it
when unpacked and keep it in a fluffy
and loose condition for a more realis-
tic ember effect.
�����
����������
����
Front Left
(BC15) Front Right
(BC16)
Rear
(BC14)
Front Center
(B138)
LG414
Fig. 39 Correct log placement for 39LDVT.
Do not place any of the lava rock material
on the burner housing assembly.