Verykool i285 - Manual (Page 33)

1.1.1.11
Remote control
When entering into the password input screen, you can enter the
security control menu list if you input the correct password (default
password is 0000).
When the function is open, there will be a reminder to set the
private command identifier, but it should contain capital and lower-
case, numbers and symbols, and should not contain less than 8
characters.
If this function is set, you can send commands to the phone that you
lost in the form of an SMS, using another phone, and the lost phone
will perform the commands, thus reaching effect of remote control.
The format of the security control command is:
Command identifier+order(+phone number)
Using the security control command can achieve the function
below:
Function
Content of order
(e.g. Command identifier is “123@!abC”;
Receiving number is “13987654321”)
Call divert 123@!abCcall divert to13987654321
Phonebook divert 123@!abCphonebook divert to13987654321
SMS divert 123@!abCsms divert to13987654321
Cancel SMS divert 123@!abCcancel sms divert
Lock 123@!abClock
Format 123@!abCformat
Power off 123@!abCpower off
1.1.1.12
Private Security
Upon entering Private Security, the password input screen appears,
where you can enter the security control menu list if you input the
correct password (default password is 0000). Then you can select
phonebook, messages, call history or file manager to set up the
privacy protection. For example: if you have set up privacy protection
for the phonebook, when you enter the phonebook, the password
input screen appears. You must input the correct password to be able
to enter and use the phonebook.
1.1.21 Wireless connect
1.1.1.13
Connection management