Centro 85-1620-6 User Manual
Page 2
W A R N I N G
Indicates an imminently hazardous situation which, if not avoided,
will result in death or serious injury.
i i
•
This kit converts your grill to natural gas at 7 inch water column supply pressure.
Verify supply pressure with your local gas company. If supply pressure is different than
7 inch, contact a certified plumber for assistance.
Not for use with LP gas.
•
Grill installation must conform with local codes, or in their absence to
National
Fuel Gas Code, NFPA 54 / ANSI Z223.1. Grill is not for use in or on recreational
vehicles and/or boats.
•
All electrical accessories (such as rotisserie) must be electrically grounded in
accordance with local codes, or
National Electrical Code, ANSI / NFPA 70.
Keep any electrical cords and/or fuel supply hoses away from any hot surfaces.
•
This grill is safety certified for use in the United States and Canada only. Do not
modify for use in any other location. Modification will result in a safety hazard.
I N S T A L L A T I O N
S A F E T Y P R E C A U T I O N S
The symbols and boxes shown below explain what each heading means. Read and follow
all of the messages found throughout the manual.
S A F E T Y
S Y M B O L S
D A N G E R
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
W A R N I N G
Indicates a potentially hazardous situation or unsafe practice which,
if not avoided, may result in minor or moderate injury.
C A U T I O N
Do not attempt to repair or alter the hose/valve/regulator
for any “assumed” defect. Any modification to this assembly will void
your warranty and create the risk of a gas leak and fire.
Use only authorized replacement parts supplied by manufacturer.
This conversion kit shall be installed in accordance with the manufacturer’s instructions and
all applicable codes and requirements of the authority having jurisdiction. If the informa-
tion in these instructions is not followed exactly, a fire, explosion or production of carbon
monoxide may result causing property damage, personal injury or loss of life. The assembler
or qualified service agency is responsible for the proper installation of this kit.
The instal-
lation is not proper and complete until the operation of the converted appliance is
checked as specified in the manufacturer’s instructions supplied with the kit.