Malone MPG460G 2010 - Manual (Page 5)

800-295-0042 ext 206 [email protected] 5
01-2010 MPG460G
FRAME ASSEMBLY (Group 1)
1. We assemble the frame on its back to make it easier to install the springs
and axle. Once the springs and axle assembly is installed we will flip the trailer
over to complete the assembly. So first, layout the frame components upside
down as shown. The spring bracket mounting holes should be facing up. All
the decals should be upside down.
2. Attach the spring
hanger brackets
to the frame. The
U shaped shackle
bolt brackets mount
to the front and the
C shaped “slipper”
brackets mount to the
rear as shown. Use
3/8” x 1” bolts and
nuts. Assemble with the nuts on the inside of the frame rails. Fully tighten all 8 bolts now.
3. Identify the hitch end of the
tongue by the 3 holes on the left
side. Insert the small wire pro-
tection grommet into the lower
hole where shown, then push it
all the way in till it snaps in place.