Microtel Series 200 - Manual (Page 10)

F. TELEPHONE LINE INSTALLATION
The connection to the telephone network is a matter of simply plugging the modular jack
cable into the telephone line termination provided by the telephone utility (RJ-11C or
equivalent).
This section contains important information regarding the installation of the telephone
line to be used by the system, and pertinent information for notifying the telephone
company of what type of line is to be installed.
The MCS is registered for direct connection to the telephone network by the FCC, which
places three restrictions on its use:
1.
The system cannot connect to a party line or a pay telephone line.
2. The telephone company must be notified that an FCC registered device is being
installed.
3. If trouble is experienced with the device, it must be immediately disconnected form
the telephone network. Microtel must make any repairs which may be necessary
in order to maintain the FCC registration status of the device.
THE FOLLOWING INFORMATION WILL BE REQUIRED BY THE TELEPHONE
UTILITY WHICH INSTALLS THE TELEPHONE LINE FOR THE SYSTEM:
1.
The FCC Registration Number, which is, D4J6M6-13598-AL-E.
2.
The Ringer Equivalence, which is 0.2B.
3.
The system needs to be connected to an RJ-11C telephone jack.
6