Microtel Series 200 - Manual (Page 15)

D. STATION IDENTIFICATION
There are two ways to enter a station identification message into the system. The
station can be identified as a number up to eight digits in length, in which case the
system will refer to itself as, "this is station XX...X". Alternatively, the system will allow
the entry of up to sixteen words from system vocabulary, to be connected together
into one identification message. For instance, the station identification "This is the
east plant" is comprised of five words from the system's vocabulary. The first case is
called the Number Mode, while the later is referred to as the Message Mode of station
identification entry.
NUMBER MODE ENTRY OF STATION IDENTIFICATION MESSAGE
1. ENTER, 0
[station number, ready]
2. Enter desired digits, terminate the entire entry with a second depression of
ENTER
[the station number is xx...x]
To read the station number for verification,
1. READ, 0
[the station number is xx...x]
MESSAGE MODE ENTRY OF STATION IDENTIFICATION MESSAGE
1. ENTER, MESSAGE,O
[station identification, ready]
2. Enter desired words by entering the appropriate two digit code for each word in
sequence from the vocabulary list found in the appendix. Terminate the entry
sequence with a second depression of ENTER.
[the station identification is ... (words), (word2), (word3)...(word 16)"]
To read the station identification message for verification,
1. READ, MESSAGE,O
[the station identification is ...(word1),(word2), (word3)...(word 16)"]
11