Microtel Series 200 - Manual (Page 22)

within 60 seconds after it has completed its call. Again, the system will verify that the
acknowledgement has been accepted by saying, [acknowledgement accepted, the
intercall delay is xx hours].
D. TEST AND ADVANCED KEYSTROKE SEQUENCES
A number of sequence commands are possible on the system front panel keyboard.
These are as follows:
ARCHIVE DATA RECOVERY
SEQUENCE 40 [the number of calls placed by the system]
SEQUENCE 41 [the number of acknowledgements returned]
SEQUENCE 42 [the number of calls placed by the system]
SEQUENCE 43 the number of power faults]
SEQUENCE 44 [the number of resets or HALT key entries]
SYSTEM LEVEL TEST SEQUENCES
SEQUENCE 50 [vocabulary dump]
SEQUENCE 52 flash test all front panel indicators (HALT to terminate this sequence)
SEQUENCE 53 calculate internal memory checksum value
SEQUENCE 55 Acknowledge tone adjustment self test
PRESET ALL DATA VALUES TO DEFAULT
NOTE: Do not use these sequences unless you are thoroughly aware of the results,
which will occur--that is, the resetting of operational data to default values, and
destroying any numbers, messages, or delays, which may have been entered by the
user.
SEQUENCE 60 preset all messages to default (Fault 1, Fault 2, etc.)
SEQUENCE 61 preset telephone numbers only (all become 0) SEQUENCE 62 reset
all archive data to 0 values
18