Microtel Series 200 - Manual (Page 7)

C. PHYSICAL SYSTEM INSTALLATION
Mount the system on a wall or other vertical surface, away from and protected from
harsh weather extremes. It is also recommended that the unit not be placed in close
proximity to high voltage (480 V and higher) electrical equipment. Four mounting
holes on the left and right side enclosure flanges are to be used for system mounting.
It is recommended that the system be mounted at eye level to facilitate ease of
programming and operation.
There are three access holes on the bottom of the unit. The left side port is for the
system's telephone line connection. The large hole on the right side of the unit is
intended for routing of the system's fault sensing leads, while the smaller hole on the
right side of the unit is for the system's power supply transformer.
The following figure shows the recommended dimensions to be used in the physical
installation of the system.
3