Vertical Communications DSU II - Manual (Page 44)

Volume Control
Setting Current Volume Level
The volume control on your telephone is a multipurpose control you can use to set
the volume (loudness) of the ringer, the speaker, the handset, the headset, back-
ground music, and the group listening mode.
· There are four ringer loudness levels
(plus an off position). Set these
levels as follows:
1. While your telephone is on-hook and idle,
PRESS the
VOLUME UP OR VOLUME
DOWN button once for each change in
loudness you desire. The ringer sounds
once for each change as an example of the
current setting. (On the 8112N, the ringer
volume is controlled by a three position
switch on the bottom of the telephone.)
NOTE: If you set the ringer to the “off” position, your telephone will sound
a short ring burst once for each call you receive at your station while the
ringer is off.
· There are at least eight handset loudness levels that you
can set for the current call as follows (not available on
8112N):
1. While on a call and in handset mode, PRESS the
VOLUME UP OR
VOLUME DOWN button once for each change in loudness that you
desire.
NOTE: When the call ends, the system resets the loudness of all future calls
to the programmed (default) setting. For instructions in setting your sta-
tion’s default volume, see Default Volume Control section in the system spe-
cific Advanced Features chapter.
Muting Your Station (not available on 8101N)
By using the
MUTE button, you can block transmission of your voice to the distant
party. You can do this whether you are using the handset or the speaker.
38 Single Line Proprietary Telephone Station User’s Guide
Other Advanced Features GCA70-246
Volume Up
Button
Volume
Down
Button
TAP
MUTE
HOLD
TRNS/CONF
INTERCOM
MESSAGE
* 0 #
WXY 9 TUV 8 PRS 7
GHI
4
JKL
5
MNO
6
DEF 3 1 ABC 2
R
TAP
MUTE
HOLD
TRNS/CONF
MESSAGE
Impact SCS Volume Buttons