Clarion VRX878RVD - Manual (Page 26)

Basic Operations
30
VRX878RVD
English
Owner
’s ma
nua
l
Switching CONNECT (connect)
Make the following settings when an external
device is connected to the Visual terminal.
Note:
• This function is not available when the Clarion
navigation system (NAX963HD) is connected.
• When the navigation system is connected, use the
monitor lock function. Locking the monitor locks
the screen size in F.WIDE mode (full wide), and
the VTR system to NTSC if the CONNECT item is
set to [COMPOSITE].
Setting the Auto Panel
When you remove or attach the DCP
(Detachable Control Panel), you can set the
liquid crystal panel automatically housing or
opening.
• The factory default setting is “OFF”.
Setting the time of air conditioner
operation mode
This setting can be used to adjust the time the
panel stays in the horizontal position when in the
air conditioner operation mode.
• The factory default setting is 10 seconds.
Selecting the PTY display language
See the section entitled “Switching the PTY
display language” (page 38).
Linking AF functions in the RDS and
DAB modes
See the section entitled “AF function between
RDS and DAB” (page 35).
RGB:
Select when the Clarion navigation system
(NAX943DV, NAX9500E) is connected.
COMPOSITE:
Select when a navigation system of the other
manufacturer is connected.
OTHERS:
Select for external devices other than a
navigation system.
NONE:
Select when no external device is connected.
• The factory default setting is “NONE”.
3-1. Touch the [
C] key to display the next menu
screen.
3-2. Touch the [
]] key of the CONNECT item to
display the CONNECT screen.
3-3. Touch the [RGB], [COMPOSITE],
[OTHERS] or [NONE] to set the function.
3-1. Touch the [
C] key to display the next menu
screen.
3-2. Touch the [ON], [OFF] or [CLOSE] key of
the AUTO PANEL item to set to “ON”, “OFF”
or “CLOSE”.
ON:
The liquid crystal panel houses
automatically after removing the DCP.
And the liquid crystal panel opens
automatically after attaching the DCP.
OFF:
Normal operation.
CLOSE:
The liquid crystal panel houses
automatically after removing the DCP.
3-1. Touch the [
C] key to display the next menu
screen.
3-2. Touch the [5s], [10s] or [30s] key of the
HVAC MODE item to set the time to “5
seconds”, “10 seconds” or “30 seconds”.