Clarion VRX878RVD - Manual (Page 60)

64
VRX878RVD
English
Owner
’s ma
nua
l
NAVI Operations (NAX963HD, etc.)
NAVI functions
Note:
• Hereafter in this section, the Navigation system will
be called as “NAVI”.
• When the Clarion NAVI NAX963HD is connected,
the following functions are available:
• Showing the NAVI display
• Operation by using the panel side buttons
• NAVI guidance voice interruption
• When the NAVI (NAX963HD) is being used…
• If the 5.1ch surround decoder (DVH943) is
connected, the voice interruptions of the
NAVI will not work.
• If the 5.1ch surround decoder (DVH943N) is
connected, the voice interruptions of the
NAVI will work.
• When a voice interrupt of the NAVI arises during 2-
ZONE ON, the sound of the MAIN zone is muted,
and the sound of the SUB zone is output normally.
When it arises during 2-ZONE OFF, the audio
signals to the 4ch speakers are attenuated, and
the voice from the navigation system is output from
the front two speakers.
• Since the Clarion NAVI (NAX963HD) is
automatically recognised, you can omit the below-
mentioned CONNECT setting.
Setting NAVI as external input
equipment
Perform this setting after connecting NAVI.
• The factory default setting is “NONE”.
1. Press the [ADJ] button, and touch the
[GENERAL] key.
2. Touch the [
]] key of the CONNECT item, and
touch the [RGB], [COMPOSITE], [OTHERS]
or [NONE] to set the function.
RGB:
Select when the Clarion NAVI (NAX943DV,
NAX9500E) is connected.
Control of it can be made only from the remote
control unit, and the NAVI voices are output
from the special speakers for the NAVI.
COMPOSITE:
Select when a NAVI of the other manufacturer
is connected.
Control of it can be made only from the remote
control unit, and the NAVI voices are output
from the special speakers for the NAVI.
OTHERS:
Select for external devices other than a NAVI.
NONE:
Select when no external device is connected.
NAVI operation
Changes between the NAVI display and the
Audio/Visual (hereinafter, refered as “AV”)
display.
Note:
• The below-mentioned [NAVI] and [AV] keys are
available only when the Clarion NAVI
(NAX963HD) is connected.
When the other NAVI is connected, use the [MAP]
button to switch the screen mode.
●AV screen
When the image interruption from the NAVI
arises, the screen will be changed from the AV
screen to the NAVI screen. When the interruption
is finished, the screen will return to the previous
AV screen.
●NAVI screen
Audio operations made in the NAVI mode will be
indicated for about 2 seconds at the bottom of the
NAVI screen.
●Operations using the buttons
[VOICE] button
• The VOICE screen of the NAVI mode is
displayed.
• When in the AV mode, it is changed to the
NAVI mode, and the VOICE operation is
performed.
[MAP] button
• The MAP screen of the NAVI mode is
displayed.
• When in the AV mode, it is changed to the
NAVI mode.
[MAP] key
[AV] key