CREATIVE AWE64 - Manual (Page 66)

16
2. You cannot hear the remote party
If Creative WebPhone always displays TALK and never displays
IN USE or LISTEN, then you must raise your Voice Activation
Level (the VOX slider in the flip door) so Creative WebPhone can
detect silence and allow the remote party to talk (this is will not be
the case if both you and the remote party have full duplex sound
cards). If this is not the case and Creative WebPhone displays
LISTEN when you would expect to hear something from the
remote party, check your Speaker volume on the flip door and in
your sound card’s mixer application. If you still cannot hear the
remote party and Creative WebPhone does not periodically display
LISTEN, the remote party’s Voice Activation Level or MIC
volume is not set correctly. Use the TXT button to launch the Text
Board and tell them to adjust their MIC and/or Voice Activation
Level.
3. The remote party cannot hear you
If Creative WebPhone always displays LISTEN, the remote party’s
MIC volume is too high and/or their Voice Activation Level is set
incorrectly so their Creative WebPhone cannot detect silence and is
constantly transmitting (not giving you an opportunity to talk). If
this is not the case and Creative WebPhone displays IN USE but
never TALK when you speak into the microphone, increase your
MIC volume and check your Voice Activation Level to verify
Creative WebPhone can detect your voice. If Creative WebPhone
does display TALK when you speak into the microphone and
LISTEN when the remote party speaks and the remote party still
cannot hear you, the remote party’s speaker volume is probably not
set correctly. Use the TXT button to launch the Text Board and tell
raise their speaker volume.
For additional information, see the NetSpeak home page, at
http://www.netspeak.com.