CREATIVE AWE64 - Manual (Page 76)

9
View Button
Clicking this button in the Legacy window opens the View window
which lists the resources reserved for a selected legacy card in your
system.
Add Button
Clicking this button in the Legacy window opens the Add window
where you can enter the following details for a new or existing legacy
card in your system (if it is not listed in the Legacy Window):
❑ Card Name
❑ Input/Output Range (I/O)
❑ Interrupt (IRQ)
❑ Direct Memory Access channel (DMA)
❑ 32-bit Memory Range (Mem)
You must enter the card’s name in the Card Name field.
The other fields can be left blank if the card does not use that
resource(s).
Remove Button
Clicking this button in the Legacy window removes a selected card’s
settings from your system. Once the settings are removed, you can
proceed to remove the card from your system.
To re-install the same card, you have to enter the card’s original
settings again. Alternatively, you can retain a card’s resource
settings by simply marking the settings for retrieval in the
Change window (refer to the next section).