Compaq DESKTOP CONNECTOR FOR ACMS AAPG9DKTE - Manual (Page 62)

You can avoid having to stop and restart VMSINSTAL by following the
directions in this section before you run VMSINSTAL. The time required for
installing gateway software is approximately five minutes.
8.3.1 Disk Space
Installing gateway software requires a certain amount of free storage space
during the installation. Table 8–1 summarizes the storage requirements for
gateway software during and after installation.
Table 8–1 Disk Space Requirements
Blocks During
Installation Blocks After
Installation
Gateway 23,304 6,500
To determine the number of free disk blocks on the current system disk, enter
the following command at the DCL prompt:
$ SHOW DEVICE SYS$SYSDEVICE
In the output column under the heading Free Blocks is the number of 512-byte
blocks available on the device.
8.3.2 Privileges and Authorization
To install gateway software, you must be logged in to an account with the
following privileges:
NETMBX
SETPRV
TMPMBX
The SYSTEM account has all the privileges you require for the installation.
VMSINSTAL turns off the BYPASS privilege at the start of the installation
and sets whatever privileges it needs during the installation.
At the end of the installation procedure, if the gateway system components
were installed, the gateway process on OpenVMS is started using the same
user name that you use to install the product. Compaq recommends that you
run the gateway under the user name SYSTEM or another user name with a
[1,4] UIC.
8–2 Preparing to Install TP Desktop Connector Gateway for ACMS Software