Compaq DESKTOP CONNECTOR FOR ACMS AAPG9DKTE - Manual (Page 77)

10
After Installing TP Desktop Connector
Gateway for ACMS Software
After installing gateway software, perform the following tasks:
• Edit OpenVMS system startup and shutdown files (see Section 10.1).
• Perform any cluster operations (see Section 10.2).
• Match client and server versions (see Section 10.3).
• Read the management chapters in the appropriate document:
Compaq TP Desktop Connector for ACMS Client Application
Programming Guide
Compaq TP Desktop Connector Getting Started
See Chapter 11 for information about how to run the Installation Verification
Procedure (IVP) after the software has been installed.
10.1 Editing the OpenVMS System Files
You must edit the OpenVMS system startup and shutdown files to provide for
automatic startup and shutdown of TP Desktop software when your system is
rebooted. (This step is usually not necessary for system upgrades.)
10.1.1 Editing the System Startup File
The following files are located in the SYS$STARTUP directory.
ACMSDI$SHUTDOWN.COM
ACMSDI$STARTUP.COM
Add to the OpenVMS system startup file the command line that starts TP
Desktop. If you separate the startup procedures into modules, be sure that you
add the lines to the correct file.
After Installing TP Desktop Connector Gateway for ACMS Software 10–1