Creda Tumble Dryer - Manual (Page 10)

10
The Controls - Advance and First Choice Models
Setting the timer
Easy Care cycle
Filter Care light
(selected models
only)
Heat Switch (OUT low heat, IN high heat) Audio Switch Start button
Filter Care Light (selected models) Empty water light Indicator
Turn the timer clockwise to select the required drying time.
The drying time for both heat settings is controlled by the timer. All you
have to do is turn the timer control clockwise until the required time
appears in line with the indicator. If you have selected more time than
you require turn the knob to select the correct time required.
The “Guide to Drying Times” section will tell you how much time you’ll
need for various loads.
This is a short programme of approximately 10 minutes to condition
previously dried clothes, see section “Easy Care Programme”. It
consists of a period of heating followed by a short cool tumble period
(as detailed below).
Select high heat for this programme. It should not be used on
damp loads as it is NOT a drying programme.
Whenever the door is opened and there is power supplied to the dryer,
the light marked ‘Filter Care’ will glow. This light advises the user to
check the filter is clear of fluff. It does not necessarily mean that the
filter is blocked or that there is anything wrong with the dryer. The light
will go out when the door is closed.
THE START BUTTON MUST BE PRESSED TO START
ALL PROGRAMMES.