Creda Tumble Dryer - Manual (Page 12)

12
The Controls Excel Models (continued)
(ii) Delayed Start
Automatic Drying
ECO Drying Light
(iii) Timed Drying
(iv) Easy Care
Cycle
When using the time delay, select the number of delay hours you
require before the drying programme is required to start.
Select the delay period by rotating the timer knob in a clockwise
direction, to the number of hours delay you require (maximum 8
hours). The dryer will start its programme when the time selected has
elapsed. If you have selected more delay than you require turn the
knob clockwise to select the correct time required. Never wind the
timer control anti-clockwise.
Note:
• Ensure that the door is closed and the start button has been
pressed after setting the required time delay period.
• If you open the door after pressing the start button, i.e. to add
articles, remember to press the start button again.
• Small loads (less than 1kg) must be dried using the timed
drying programme.
This light will glow when ECO drying is selected. It will stop glowing
when the load is dry, the programme then advances to the ‘Cool
Tumble’ phase.
A short programme of around 20 minutes is provided to dry small loads
of less than 1kg.
To select this programme, turn the timer control clockwise until the 20
appears in line with the indicator. Never wind the timer control anti-
clockwise.
About 5 minutes before the programme is completed, the heating
elements are switched off and the programme enters the final ‘Cool
Tumble’ phase.
This is a short programme of approximately 10 minutes to condition
previously dried clothes. See section ‘Easy Care Programme’.
It consists of a period of heating followed by a short cool tumble
period (as detailed below).
Select high heat for this programme.
It should not be used on damp loads, as it is NOT a drying
programme.