Creda Tumble Dryer - Manual (Page 16)

Emptying the Water Container
Do not block the vent hole in the cap!
This hole is essential for correct operation of your dryer.
Remove plinth (where fitted) by slightly lifting and sliding to the left.
Pull the container out of the dryer (a small amount of water may leak
from the vent hole if the container is tilted).
Remove the cap and empty the container into a sink (or other suitable
drain).
If your dryer is stacked on top of a Washing Machine, the Tumble
Dryer can be plumbed into the drain by attaching a suitable tube to the
stub at the rear of the dryer, after removing the blanking cap. When
plumbed into a drain the water container does not need to be emptied.
Empty the water container after EVERY programme.
Failure to do this will result in the water container
becoming full and the load will not dry.
Water
Container
Plinth
Moulding
(not fitted to
all models)
Sink
Water
Container
To Empty Water
Container
16