Creda Tumble Dryer - Manual (Page 9)

9
The Controls - All Models
Selecting the
required Heat
Switch Setting
Starting the Dryer
Empty Water Light
The ‘Cool Tumble’
phase
Audio Signal
(Buzzer)
To select high heat (Cottons), the heat selection switch must be In.
To select Low heat (Acrylics and Synthetics), the heat selection switch
must be Out, a blue indicator will be visible on the top of the switch.
See section “Guide to Drying Times”.
Press and release the START Drying button to commence a drying
programme (or delayed start programme on Excel models). The door
must have been securely closed first.
After releasing the start button, it will return to its original position.
This light will glow when the water container is full.
You should not wait for this light to glow before emptying the
container, but empty it after each load (See section “Emptying the
Water Container”).
NOTE: If the light glows during a programme you must stop the dryer
and empty the water container. If this is not done the timer will
advance to the Cool Tumble phase without drying the load.
The light will take approximately 10 seconds to go out after replacing
the empty container.
About 10 minutes before the programme is completed, the heating
elements will be switched off and the programme enters the final
‘Cool Tumble’ phase. During this period, the fabric is cooled. You
should always allow the dryer to complete this phase.
By opening the door you can check the dryness of the load as often
as you wish, and if you want to remove some items before they are
fully dry. (This is particularly useful for a mixed load, where you want
to iron some items but others are to be fully dried). You will need to
press the start button after closing the door to restart the
programme. See section “The Controls”.
After completion of the ‘Cool Tumble” phase, a buzzer (if selected) will
indicate that the programme has finished.
To silence the alarm, open the door or press the Audio Signal button.
This option is cancelled with the Audio Signal button IN and selected
with the button OUT.
NOTE: If the door is opened during a programme, the dryer
will automatically stop.
To continue the programme after closing the door, the
START button must be pressed again.