Continental BCDV42N - Manual (Page 19)

19
W415-0385 / A / 10.02.03
1. Remove the upper louvres, and open the glass door.
Remove the logs.
2. Remove the securing screw al-
ready in place at the back of the fire-
box. If the unit is supplied with a rear
log support, remove before install-
ing the rear brick panel. Place the
rear panel against the back of the
firebox and re-install the rear log support over the brick
panel, if supplied. Secure using the original screw.
3. Remove the two securing screws located on either fire-
box side.
4. Place the left brick panel
against the left side of the firebox,
ensuring that it butts up to the rear
panel. Secure in place using 2 of
the screws previously removed.
Repeat for the right side.
5. Replace the logs, glass door
and louvres.
NOTE: MBP42 Shown. Mortar lines not available on PRP42.
The appearance of the panels will permanently lighten in
colour with use.
B
A
FIGURE 38
UPPER LOUVRES
Insert the louvre tabs into the
slots located at the top left and
right corners of the unit.
S L O T
TA B
A
LOWER LOUVRES
Insert the hinge clips into the
slots located at the bottom left
and right corners of the unit.
To remove the louvres, pull the
back tabs of the clips forward,
while pushing the louvre assem-
bly back. Lift the clip.
B
HINGE
CLIP
S L O T
Remove the
backing of the
logo supplied and
place on the glass
viewing door, as
indicated.
FIGURE 39
L42 LOUVRE INSTALLATION
LOGO
½"
½"
FINISHING
LOGO PLACEMENT
PORCELAIN REFLECTIVE PANELS
FIGURES 40a-b
FIGURES 40a
FIGURE 40b