Vertical Communications EP100 - Manual (Page 77)

CONVERSip EP100 User
Sept ‘04
Comdial 79
6. Dial reminder time using the
numbers on the dial pad (remem-
ber to dial a zero before single
digit times: 01 for one o’clock,
02 for 2 o’clock, etc.).
7. Set AM or PM.
8. Select SAVE.
9. Press SPEAKER to quit.
When an alert sounds at the set time, you hear four short tone bursts,
which continues until acted upon. If you are not at your station to
hear the alert when it sounds, your telephone’s ring tone changes to
the alert tone for every incoming call until you respond to the alert.
To respond to an alert after it sounds,
choose one of the following:
1. Select CLEAR to turn off the
alert.
2. Select SET to reset the alert for
the same time the following day.
6.6 Response Message Button
You may program a RESPONSE MESSAGE button, which allows
you to send an LCD message to a caller who has initiated a SOHVA
or intercom call from another LCD speakerphone. It also allows you
to send an LCD message to another LCD speakerphone when you call
and receive a busy signal or no answer.
To store a scrolling RESPONSE MESSAGE button, proceed as
follows (user may press button repeatedly to choose from up to 30
system supplied messages),
1. Press INTERCOM.
2. Dial **6.
Time: 10:30 AM
SAVE PM EXIT
Setting the Alert Time
ALERT 1 10:30 AM
SET CLEAR
Responding to an Alert