Pro Boat JR XR3i - Manual (Page 28)

28
The Sub-Trim function of the XR3i is an electronic trimming
feature that allows the neutral position of the servo on either
the steering, throttle or auxiliary channel (optional) to be
moved, while allowing the electronic trim lever for that
channel to remain in the center position. This feature is very
useful as it allows the servo arm/wheel position to be moved
to help with control linkage installation, eliminating the need
to make mechanical linkage adjustments.
Although the Sub-Trim function is a very useful feature, it is
suggested that only small amounts of sub-trim be used so
that no unwanted, non-equal servo travel is created. It is
suggested that less than 30 points of Sub-Trim be used
during adjustment. If more than 30 points of Sub-Trim are
required, it is suggested that a mechanical linkage
adjustment be performed.
Accessing the Sub-Trim Function
1. Turn on the transmitter power switch.
2. Press the Scroll key to enter Function mode.
3. Press the Scroll key until "TRIM" appears in small letters
to the left of the screen.
4. Press the Channel key to select the channel to be adjusted
(Steering, Throttle or Auxiliary Channel 3).
5. Press the Increase or Decrease keys until the proper servo
position is achieved.
6. Press the Scroll key to access the Servo Reversing
function.
7. To exit the Function mode, either turn off the transmitter
power switch or press the Scroll and Channel keys at the
same time.
sts
0
T R I M
Current Channel
STS = Steering
THS = Throttle
AUS = Auxiliary
Channel 3
Current Value
Press the Channel key
to select the desired
channel to be adjusted.
STS = Steering
THS = Throttle
AUS = Auxiliary
Channel 3
Press the Scroll key
until "TRIM" appears
on the screen.
Press the Increase or Decrease keys to achieve
the desired Sub-Trim Value.
Values: R/B 125 0 R/F 125
SCROLL
ENTER
CHANNEL
INCREASE
CLEAR
DECREASE
Sub-Trim (Function Mode)
4680 JR XR3i manual 7/17/02 12:14 PM Page 28