Pro Boat JR XR3i - Manual (Page 31)

31
The XR3i electronic Steering Trim lever, located just above
the steering wheel, allows the center position of the servo
to be manipulated in either direction to achieve precise
centering of the steering assembly. Steering travel end-point
adjustment values (page 24) remain completely independent
from the steering trim, unless the trim value exceeds the
selected end-point values. (For example, if trim values are
set at 30 and end-point values at 15, steering trim will over-
ride/alter the end-point value.)
Each click will provide 0.3° of trim to the center of the
steering servo with a maximum of 12° allowed.
Note: Each click will not always result in a
change of the value displayed.
To adjust the steering trim servo position, move the
electronic Steering Trim lever either to the left or the right.
As soon as the trim is moved, the "STC" Steering Trim
screen will appear and will continue to be displayed unless
the trim lever is untouched for a period of two seconds. To
reset the trim value to 0, press the Increase and Decrease
keys at the same time while the "STC" screen is displayed.
T R I M .
Values: L/F 30 0 R/B 30
stc
0
Steering Trim
Screen
Current Value
Press the Increase and Decrease keys at the
same time to reset the steering trim to zero.
Steering Trim Location
Right Trim Left Trim
INCREASE
CLEAR
DECREASE
ST.
Steering Trim
Steering Trim (STC)
4680 JR XR3i manual 7/17/02 12:14 PM Page 31