RED ROCKET-X - Manual (Page 14)

COPYRIGHT © 2014 RED.COM, INC
RED ROCKET-X INSTALLATION INSTRUCTIONS
955-0033, REV-B | 14
20. Place the PCI bracket under the brace and tighten the two (2) thumbscrews to secure the RED ROCKET-X.
NOTE: The photo below shows the system without the HD-SDI slot filer installed.
21. Reinstall any cards you removed from the system.
22. Reinstall any hard drives you removed from the system.
23. Slide the PCIe fan toward the RED ROCKET-X until it locks back into place.
24. Reinstall the side access panel.
25. Reconnect all cables to the computer system.
26. To install or upgrade the RED ROCKET-X driver and firmware, go to
“Install Driver and Firmware” on page
24 .
Install PCI Bracket
Slide PCIe Fan to
Original Position