CPG PageMaster 402N - Manual (Page 55)

Apr 02
Compuprint PageMaster 402N User Guide 3-13
System Menu
System Menu
The system menu provides access to system settings. Use the following procedure to enter the sys-
tem menu:
1. Press the MENU button on the control panel.
2. Press the NEXT button until the text “System Menu” is shown on the second line of the dis-
play.
3. Press the SELECT button to enter the system menu.
4. Press the NEXT button to move through the submenus: Factory Defaults, Display Lan-
guage, Power Saver, Wait Timeout, Job Timeout, Jam Recovery, and Hex Print.
5. Press the SELECT button to enter a submenu.
6. Use the procedures in the following table to access and change the system settings:
Submenus Default Setting Available Settings Procedure for Changing Setting
Factory Defaults
This submenu allows you to reset the
printer to U.S. or Non-U.S. factory
defaults. U.S. U.S.
Non-U.S. 1. Press NEXT or PREVIOUS to toggles
between U.S. and NON-U.S.
2. Press SELECT to choose and set the
factory defaults.
Display Language
This submenu allows you to change
the language of the display messages. English English
French
German
Italian
Spanish 1. Press NEXT or PREVIOUS to scroll
through the available languages:
English, French (Francais), German
(Deutsch), Italian (Italiano), or
Spanish (Espanol).
2. Press SELECT to choose and set the
language.
Power Saver
This submenu allows you to set the
number of minutes the printer is idle
before it reverts to Power Saver
Mode. 15 0 - 999 1. Press NEXT or PREVIOUS to
increase or decrease the number of
minutes.
2. Press SELECT to save this setting.
Wait Timeout
This submenu allows you to increase
or decrease the length of time (in
seconds) that the printer will remain
in the waiting state—a job is being
processed, no end-of-file has been
detected, and there is no more data to
process. This setting applies to both
PCL and PostScript print jobs. 20 0 - 99999 1. Press NEXT or PREVIOUS to
increase or decrease each digit of the
five-digit number.
2. Press SELECT set one digit and move
to the next digit.
3. Press SELECT after changing the last
digit to save this setting.
Job Timeout
This submenu allows you to increase
or decrease the time limit (in
seconds) for PostScript jobs. A 0
setting indicates no timeout. This
setting applies only to PostScript
jobs. 0 0 - 99999 1. Press NEXT or PREVIOUS to
increase or decrease each digit of the
five-digit number.
2. Press SELECT set one digit and move
to the next digit.
3. Press SELECT after changing the last
digit to save this setting.