Sceptre X42BV-FULLHD - Manual (Page 29)

SCEPTRE X42 HDTV User Manual
- 29 -
www.SCEPTRE.com
If You have Cable or Antenna…
1. Make sure the power of X42 LCD HDTV is turned off.
2. Connect the Coaxial RF cable from your antenna or cable to the
ATSC/NTSC port off the back of your X42 LCD HDTV.
3. Turn on the X42 LCD HDTV.
4. Select TV (Air) for antenna or TV (Cable) for cable from either your
remote control’s source button or source button on the right side of
the TV.
5. Use the On Screen Display to scan for channels.
Please Note :
• Not all broadcasts are in High Definition (HD). Please refer to
your local broadcasting stations for more information.
• The X42 LCD HDTV’s tuner is designed for HDTV therefore
requires a stronger signal than normal TVs. If you cannot
achieve that signal level with your antenna or cable, your X42
LCD HDTV might lose picture or sound.
• This TV will turn off automatically if there’s no signal present for
more than 15 minutes.