Sceptre X42BV-FULLHD - Manual (Page 40)

SCEPTRE X42 HDTV User Manual
- 40 -
www.SCEPTRE.com
If You Want the good Connection with VGA
(Analog)…
1. Make sure the power of X42 LCD HDTV and your PC is turned off.
2. Obtain a 15-pin D-Sub VGA cable, connect to the VGA output of
your PC and the other end to the VGA port off the back of your X42
LCD HDTV.
3. Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC and
the other end to the VGA Stereo Input port.
4. Turn on the power of the X42 LCD HDTV and your PC.
5. Use the remote control’s source button or the source button on the
right side of the TV to switch to VGA.
Please Note :
• For the best picture, please set your PC resolution to
1920x1080 at 60 Hz. Please refer to the PC or graphic
card’s manual for further instructions on how to set your
resolution and refresh rate.
• Please refer to your PC manual for video output
requirements of the video card.
• The VGA port of the TV features a power saving mode which
will automatically turn off the TV, if there’s no signal provided
for more than 15 minutes.