Scientech Zeta Series - Manual (Page 24)

24
Quick Setup Guide:
Adjust the FRONT FEET to level the balance by centering the
LEVEL INDICATOR.
4
CONNECT BALANCE
TO ELECTRICAL OUTLET
3
LEVEL BALANCE
2
PLACE IN PROPER
ENVIRONMENT
1
UNPACK BALANCE
Thumbwheel
but does not rotate.
The shaft moves in and out
against bottom of case.
in the same position
turns but stays
Calibration instructions in manual.
6
WARM UP 1 HR, THEN
CALIBRATE
Press the ON/OFF switch and make sure the balance
goes through the following sequence.
5
TURN ON BALANCE
Rotating thumbwheel('s) as
RAISES front of balance.
extend out of case and
shown causes Shaft to