Scientech Zeta Series - Manual (Page 4)

4
Level the Balance:
Adjust (turn) the front feet (see Figure 2) to level the balance by centering the bubble in the level indicator which is shown in Figure 1.
Turning the foot as shown below raises that side of the balance and an opposite adjustment lowers it. When properly adjusted the
metal center shaft of the assembly will protrude from the center of the plastic foot and will support the balance. The plastic foot will
be raised up against the bottom of the balance and will not be touching the weighing table.
Figure 2 Leveling
Connect to an Electrical Outlet:
The balance is supplied with a 100/240, 50/60 Hz automatic switching, remote power supply. This power supply will work with most
electrical outlets. However, before making any connections, verify that the power (VAC) requirement shown on the remote power
supply is compatible with the AC power outlet to which the balance will be connected. A standard line cord is provided to connect the
power supply to the electrical outlet; however, there are many different outlet configurations. If a different line cord is required it
must have an IEC connector to plug into the power supply and whatever plug is appropriate for your electrical outlet.
Note: First plug the round DIN connector into the balance’s rear panel receptacle. Then, plug the power supply into a
grounded AC outlet.
Note: Do not alter or bypass the ground plug in any way. Doing so adversely affects the performance of the balance.
Note: Scientech recommends that the balance be plugged into an electrical outlet at all times. This insures the balance is
always warmed up and ready for use.
Turn the balance on:
Press the ON/OFF button one time to turn the balance on and observe the following turn on sequence.
Figure 3 Turn On sequence
After the balance has been plugged in and turned on, allow it to warm up for at least 1 hour, then follow the Autocalibration
instructions to calibrate the balance.