SIG SAUER P320 - Manual (Page 36)

www.sigsauer.com 36
8.3 cleaning the Pistol
waRning
never clean the barrel from the muzzle end; do not use a steel wire brush as it
can damage the smooth surface of the barrel. use a suitable cleaning rod and a
bronze brush of the correct caliber.
Solvents can be harmful to the surface finish of the pistol. read and follow the
manufacturer’s warnings before using solvents or cleaners. Wear eye protection.
avoid over-lubrication of components.
caution: avoid over
lubrication of components.
1. lubricate the cleaning brush with gun
oil and insert it into the barrel via the
chamber (opposite the muzzle end).
2. Wipe powder residues and oil from
the barrel bore and chamber with clean-
ing patches.
3. clean exterior surfaces of the barrel
with a brush coated with gun oil.
4. remove dirt from guides of the frame,
inside and outside of slide, recoil spring
guide and recoil spring with a brush or
cleaning patch. lightly lubricate same
surfaces with a cloth impregnated with
gun oil or gun grease.
5. lightly oil bores of the barrel and
chamber. remove any excess lubricant.
Slide
Barrel
Recoil Recoil
Spring Guide
Frame
Grip Module
Takedown
Lever
Trigger