Crestron electronic ST-1700C - Manual (Page 23)

Crestron ST-1700C 1-Way Wireless RF Touchpanel
Configuration Manager is where programmers “build” a Crestron control system by
selecting hardware from the Device Library. In Configuration Manager, drag the PRO2
from the Control Systems folder of the Device Library and drop it in the upper pane of
the System Views. The PRO2 with its associated communication ports is displayed in
the System Views upper pane.
PRO2 System View
The System Views lower pane displays the PRO2 system tree. This tree can be
expanded to display and configure the communications ports.
Expanded PRO2 System Tree
C2Net-Device Slot in Configuration Manager
To incorporate a wireless RF touchpanel into the system, a gateway device is required.
The C2Net-Device Slot can accept a gateway such as the CNRFGWA. Once a gateway
is configured in a C2Net-Device Slot, the slot allows Cresnet communication between
the touchpanel and the control system.
In Configuration Manager, drag the CNRFGWA gateway from the Wireless Receivers
(RF) folder of the Device Library. The System Views upper pane displays the
CNRFGWA device icon below the PRO2 graphic.
NOTE: An ST-CP control processor is automatically configured with a CNRFGWA
in its STCP-Net Device Slot 3, with a fixed NET ID of 2, when the ST-CP is dragged
into the upper pane of System Views.
Drag the ST-1700C from the Touchpanels (Wireless | Wireless one way) folder of the
Device Library and drop it on the CNRFGWA symbol in System Views. The PRO2
system tree displays the CNRFGWA gateway in Slot 9, with a default NET ID of 24.
The CNRFGWA displays the touchpanel at the touchpanel’s default RF ID location,
“10,” as shown in the following illustration.
Operations Guide – DOC. 6050 1-Way Wireless RF Touchpanel: ST-1700C • 19