SmarTek Systems TMS-2 - Manual (Page 17)

TMS-2 TMS-USI Menu
S
S
SmarTek Systems
410-315-9727
[email protected]
www.smarteksys.com
R
R
Get TMS ID – USI responds with its ID (TMSxxxx)
Get TMS Parameters – USI responds with its parameters
Get TMS Date and Time – USI responds with its date and time
Get TMS Archive Data – USI sends the archive data line by line until complete
Archive file is saved in the Arch_Data sub-folder using
the name specified in the General Parameters. The
archive file is a space delimited, spread sheet ready file.
Send TMS Parameters – TMS-2 Monitor sends its current parameters to the USI
Set TMS Date and Time – TMS-2 Monitor sends its date and time (PC clock) to the USI
Note: This will reset the Data Archive in the USI.
Add TMS Temperature Probes – Begins the procedure to identify and add additional
temperature probes to the existing list or creates a new
list.
Change TMS ID – Changes the USI ID from the Current ID to the New ID
Change TMS Baud Rate – Changes the USI Sys Port baud rate
Note: This requires that the TMS-2 Monitor baud rate
be changed as well to match the USI.
Reset TMS – Causes the USI to Reset