SmarTek Systems TMS-2 - Manual (Page 9)

TMS-2 Start Window – Open Parameter File
S
S
SmarTek Systems
410-315-9727
[email protected]
www.smarteksys.com
R
R
After clicking one of the connectivity buttons on the opening window, this Standard Windows File Open
Window appears. Select a parameter file (.smp) and click Open to start the TMS-2 program.
The file selection is not critical when connected to a USI that is already setup and operating.
As shown on the next page, as soon as the TMS-2 Monitor Main window appears, the user
should perform a Get TMS ID and then a Get TMS Parameters via the TMS-USI pull-down
menus. This action loads the TMS-2 parameters from the USI and thus overwrites the
parameters that were loaded from the file on startup.